call account
Tensorgrip L40 Webspray Adhesive

Tensorgrip L40 Webspray Adhesive

5.60 incl VAT
4.55 excl VAT
Tensorgrip L40 Webspray Adhesive is a general purpose fast drying, sprayable contact adhesive, available in a 500ml aerosol. Read more
Quantity
Quantity:
- +

This product is currently out of stock


Tensorgrip L40 Webspray Adhesive is a general purpose fast drying, sprayable contact adhesive.

Tensorgrip L40 Webspray Adhesive is suitable for bonding a wide variety of materials to sheet timber, metal, EPDM rubber and some hard plastics. It will bond foams, fabrics, and other fibrous materials. This is a fast drying sprayable contact adhesive. It has good heat resistance and easy application control. This is a portable system with no pressurized air required. The spray system requires very little additional equipment and needs minimal cleaning of equipment.

  • Bonding PVC high pressure laminates to plywood, MDF, chipboard etc
  • Bonding EPDM in a roofing application
  • Gluing sheet metal (pvc coated steel, aluminum, powder/ painted steel)
  • Shopfitting and joinery applications
  • This product is designed to be applied to two surfaces to be bonded together. Make sure that surfaces are clean, dry and free from dirt, dust, oil, loose paint, wax or grease, etc. For best results, the temperature of the adhesive and the surfaces being bonded should be between 60 degrees F – 80 degrees F (16degrees C – 27 degrees C).
  • Use with adequate ventilation. 
  • Prior to use, Check compatibility by spraying a small test patch of the adhesive on the substrate. This product may degrade some substrates. Spray about 10-20 cm (4” – 8”) away at a 90 degree angle to the surface, applying a uniform, even coat of adhesive to obtain 80% to 100% coverage of the surface. If necessary, spray another coat of adhesive in areas that appear to need more adhesive. Spray both surfaces to be bonded, one surface vertically and the other surface horizontally. Allow the adhesive to tack off until no adhesive transfers to the knuckle when touched.
  • Adhere surfaces and press together with adequate pressure. A roller is recommended to apply a uniform pressure to achieve maximum strength. Allow 24 hours for the adhesive to fully cure.